Rigid liners
Straight flues can take rigid stainless pipe and holds up to frequent cleaning.
A DuBois chimney sweep can reline your chimney to protect the masonry and keep heat away from the framing around it. One call to (814) 913-0171 reaches a nearby sweep who installs liners.
A chimney liner is the channel inside the chimney that carries smoke and combustion gases up and out. It keeps heat from reaching wood framing next to the chimney, protects the brick and mortar from corrosive gases and gives the appliance a flue of the right size to draft well. Some older chimneys were built unlined, and others have clay tiles that have cracked over the decades.
There are a few reasons a chimney gets a new liner. The original clay tiles may be cracked from age, settling or a chimney fire, or the chimney may never have been lined. Installing an insert, stove or high efficiency furnace often means the old flue is the wrong size.
Industry standards based on NFPA 211 call for a Level 2 inspection when an appliance is changed or after a chimney fire. That reveals whether the existing tiles can be repaired or need to be replaced, and it shows the route a new liner will take. You can ask the sweep to walk you through the video.
If the problem goes deeper than it first looked, a DuBois chimney sweep may also recommend chimney liner repair or chimney inspection.
Need chimney liner installation in DuBois? Call (814) 913-0171 and describe the problem to a chimney sweep who works in DuBois.
Call nowRelining a chimney is a careful job that starts well before the liner goes in.
The sweep inspects the flue from top to bottom, usually with a video camera. It decides between repair and relining.
The right diameter depends on the stove, insert, furnace or fireplace being vented. The full height of the flue is measured too.
The flue is swept and any loose tile or obstruction is cleared so the liner can pass. Some chimneys need old tiles broken out to fit an insulated liner.
A flexible liner is fed down the flue, while rigid sections are joined as they go. Many liner systems are tested with insulation for clearance to combustibles.
A tee or connector joins the liner to the appliance, and a top plate seals the crown. Every joint is secured so gases stay inside the liner.
The sweep checks the draft and looks for any leaks. This is also a good time to test your CO alarms.
Straight flues can take rigid stainless pipe and holds up to frequent cleaning.
Insulation is wrapped around the liner or poured into the space around it which improves draft and limits creosote.
A cement based mix is poured around a form inside the chimney to create a smooth new flue in a single solid lining.
A flexible liner works in chimneys that are not perfectly straight and come in grades matched to the fuel.
A properly sized liner for a water heater left alone after a furnace upgrade stop condensation from damaging the chimney.
A stainless steel liner is the standard choice for most homes that need a new flue. Flexible stainless goes around offsets in a chimney, and rigid stainless suits straight runs. The sweep picks a grade of stainless that suits the fuel the appliance burns.
Insulation around the liner helps flue gases rise and keeps the outside of the chimney cooler. At the top, a sealing plate and cap keep rain and animals out. Many DuBois chimneys get a stainless liner when an old fireplace is converted to an insert.
A chimney is relined when the existing flue cannot safely vent the appliance. The most common triggers are chimney fires, settling cracks, missing mortar and appliance changes. In most cases the work is done from the top without tearing into the house.
When you call (814) 913-0171, tell the sweep what vents into the chimney, such as a fireplace, stove, furnace or water heater. An orphaned water heater, left behind when a new furnace vents elsewhere, is a common reason to reline. A smaller liner brings the draft back where it should be.
Around DuBois, relining usually comes up when a home changes heating appliances or an inspection turns up cracked tiles. From DuBois out to places nearby like Sandy, Treasure Lake, Punxsutawney and Brookville, wood stoves and inserts are common, and each one needs a properly sized liner, which is why relining is one of the most common chimney upgrades in the area.
Need chimney liner installation around DuBois? Call (814) 913-0171 for a DuBois chimney sweep who serves the towns around it too.
Cold winters keep fireplaces, wood stoves and oil burners working for half the year or more. The hardest thing on brick here is not the cold itself but the constant swing above and below freezing: water soaks into brick, mortar joints and the crown on a mild day, freezes overnight and expands, which is how cracks, loose bricks and leaks start. Nor'easters drive rain sideways into flashing and mortar that looked fine in summer. That is why chimney cleaning in DuBois is usually booked in the fall, before the first cold night.
Small chimney problems caught early usually stay small repairs.
Local sweeps see the same chimney types and weather wear across DuBois and nearby towns.
Ask the sweep about the cause, the options and the estimate before work starts.
More questions? Call (814) 913-0171
Fixing gaps, cracks and missing mortar inside the flue liner after a camera scan shows where the damage is.
Learn moreAn annual look at the flue, firebox, damper, crown and cap to catch cracks, blockages and leaks before they turn into hazards.
Learn moreInsert installation for drafty, inefficient open fireplaces, with the chimney inspected before anything goes in.
Learn moreInstalling freestanding wood stoves with the right clearances, hearth and venting, so the stove drafts well and stays clear of anything that can burn.
Learn moreLooking for something else?
See all chimney servicesCall (814) 913-0171 to talk to a chimney sweep serving DuBois, PA.
Free to call. No forms to fill out.